Guilds/CCHC/Guides/Carp Blade

Making a carp Blade in 22 blows

This is a Carpentry Blade guide based off of Eldrads Guide. Thanks go to him and his guide, several of the things I say will mirror what he said, but i'm going off of what I do, no Reading his guide, and the images contained withen, were made by me. I hope this helps you.

Step 1

First off I start in F8 single mode, not the overhead veiw. The anvil is aligned horizontally with the front, or flat part of the blad facing south. I pin all 4 menus up in an easy to display method, whatever is easiest for you but, the goal menu which includes the tools menu, force menu, menu used to place a carp blade, and the menu to complete blade.

You start by hitting the 8 spots listed below, using the shaping mallot at force level 8. This is not as importent as some of the steps, but you must hit at the very edge, as close to the edge as you can get your mouse pointer.

Step 2

On this step you want hit the 4 spots listed below with Wide Tungsten Chisel, on force level 9. You start by hitting the left most dot, then the right most dot, then either order for the 2 middle dots. now it these 2 dots, if you hit these 2 dots correctly you'll still be able to see the pattern in the metal, the patern does not change per person, or anvil, it always stay the same.

Step 3

Rotate your veiw so that the blade part is facing north. Switch your Wide Tungesten Chisel to force level 4 and hit the 3 spots listed below.

Step 4

Switch to BallPeen Hammer set your force level to 9. Hit the 2 spots pictured below.

Step 5

Hit the following to spots pictured below keeping with the ballpeen hammer at force level 9

---

The Following are the front and back images of your carpentry blade so far.

The Front of your Blade should look like this.

The Back of your Blade should look like this.