The Wiki for Tale 4 is in read-only mode and is available for archival and reference purposes only. Please visit the current Tale 11 Wiki in the meantime.

If you have any issues with this Wiki, please post in #wiki-editing on Discord or contact Brad in-game.

Kettle

From A Tale in the Desert
Revision as of 00:39, 9 January 2009 by Shebi (talk | contribs) (→‎Products)
Jump to navigationJump to search

A Kettle is used for reducing various liquids by boiling.

There are two methods used for the kettle:

  • Non-stoked - load with requirements including wood, leave until complete.
  • Stoked - load with requirements, stoke with wood and ignite, continue to add wood/stoke as it burns down until the liquid is boiled off. For stoked runs (see details below), you will need 28 wood per kettle (assuming no mistakes), with the total process taking about 14 teppy minutes (30 teppysec per tic).


PinkBox.png
Size 5x5
Where Compound




Source

This building becomes available after you have learned the Cooking skill. Specific recipes may require additional techs or skills (see below).

Cost

Built in a Compound. Uses 5x5 cells.

Products

Output Input Method Tech/Skill Needed
5 Potash 5 Ash, 25 Water in Jugs (jugs not consumed) Stoked None
50 Flower Fertilizer 1 Catfish, 1 Perch Fish, 1 Tilapia Fish, 5 Water in Jugs, 5 Wood Non-stoked Horticulture
50 Grain Fertilizer 1 Carp Fish, 5 Water in Jugs, 5 Wood Non-stoked Barley Cultivation
50 Weed Killer 1 Toad Skin Mushrooms, 5 Water in Jugs, 5 wood]] Non-stoked Barley Cultivation
25 Sulfur 25 Sulphurous Water Stoked Desiccation (1)
3 Salt 25 Coconut Water Stoked Desiccation (2) to configure kettle but not to run it
3 Acid 25 Sulphurous Water, 1 Salt Stoked Desiccation (3)
8 Arsenic 1 Razor's Edge Mushroom, 1 Scorpion's Brood Mushroom, 5 Oil, 5 Wood Non-stoked Toxin Extraction

NOTE: Sulfur can also be made by evaporating sulphurous water in a tub, which does not use wood or require any skills. Basic and Sturdy Tubs break with usage.

Use

In general terms, it works as follows:

  • Once the kettle is ignited, it runs in a series of 30-teppysecond ticks. At the beginning of each tick, it consumes one deben of wood. At the end of the tick, it evaporates one deben of water. (Meaning that most of the time, except for the very beginning and end of the batch, it will consume one wood and one water simultaneously every 30 tsec.)
  • The first three ticks after igniting are "warm-up" ticks... wood is consumed, but no water is evaporated.
  • If at the beginning of a tick there is no wood left under the kettle, the fire goes out. The batch isn't ruined, but the fire will have to be reignited, and will go through the warm-up process again, wasting time and wood.
  • You can stoke the kettle at any time to add wood, but it will only hold up to 5 at once.

Stoking Run

  1. Load requirements
  2. Ignite (cost 5 wood)
  • Burns off 1 wood in lighting
  • Fire burns till 0 (4 wood)
  1. At 0 wood stoke 5; water is at 24 now
  2. At 0 wood stoke 5; water is at 19 now
  3. At 0 wood stoke 5; water is at 14 now
  4. At 0 wood stoke 5; water is at 9 now
  5. At 2 wood stoke 3; water is at 6 now
  6. Let burn out
  7. Take the product (don't discard!)

Notes

  • In total you will need 28 wood per kettle (assuming no mistakes).
  • Total process takes about 14 teppy minutes (30 teppysec per tic).